CPC
PGR018 Engine Protection Shutdown
Type #1 Eng Shtdn Enable Disabled
PGR035 Digital Outputs
1 05 DO Selection 0 Disabled
1 13 DO Selection 0 Disabled
3 10 DO Selection Disabled
4 07 DO Selection Disabled
1 05 DO Configuration Disabled
0 13 DO Configuration Disabled
3 10 DO Configuration Disabled
4 07 DO Configuration Disabled
PGR046 Diesel Particulate Filter
DPF Ash Mileage SYnc MU Enable Disabled
DPF J1939 Regen Sw Enable Not Active
DPF Soot Load Eng Shtdn Enable Disabled
DPF Veh Speed THresh Enable Off
SEND TO CPC
MCM
PGR002_SensorConfig
Doser Pressure Inlet Not Installed
PGR007_DPFConfig
DPF HEST Max Speed Threshold 127
DPF Min Vehicle Speed 157.8
e2p_is2_ccv_dev_avl_b Disabled
e2p_isp_p_low_fuel_active_b Disabled
DPF Diag Slow On Enable Disabled
DPF Shutdown Enable Disabled
PGR010
PGR025 EGR
PGR024_SensorConfig_2
Position of Intake Air THrottle Not Active
Exhaust Pressure Befor DPF Inlet Not Active
Outlet Temperature DOC Not Active
Inlet Temperature DOC Not Active
Outlet Temperature DPF Not Active
Pressure After DPF Outlet Not Active
Doser Pressure Outlet Not Active
EGR Valve Position Not Active
PGR025_EBMConfig
CAN Actuator 3 EGR
PGR055_DPF_Config_2
e2p_30g_nox_enable Disable
SEND to MCM
ACM
ACC005_SCR
ucm_DEF_mass_nom_start 0.00
ucm_Defmass_tank_begin 0.00
ucm_DEF_mass_tanks_last 0.00
SEND TO ACM
ACM
PGR001_CAN_Config
CAN3 Baudrate Not Defined
NOX_Sensor_CAN_Baudrate Not Defined
PGR002_Output_Config1
SCR Line Heater 2 Enable 0
SCR Line Heater 4 Enable 0
SCR Line Heater 5 Enable 0
PGR005_DPF
Extended Idle Auto RPM Elevate Disabled
DPF MIN Vehicle Speed 157
PGR006_DEF_Tank_Level
DEF_Level_Sensor_Cal_Level_7 99.9
DEF_Level_Sensor_Cal_Level_6 99.9
DEF_Level_Sensor_Cal_Level_5 99.9
DEF_Level_Sensor_Cal_Level_4 99.9
DEF_Level_Sensor_Cal_Level_3 99.9
DEF_Level_Sensor_Cal_Level_2 99.9
DEF_Level_Sensor_Cal_Level_1 99.9
PGR011_DEF
isp_I_Def_tank_can_2m[6] 99.9
isp_I_Def_tank_can_2m[5] 99.9
isp_I_Def_tank_can_2m[4] 99.9
isp_I_Def_tank_can_2m[3] 99.9
isp_I_Def_tank_can_2m[2] 99.9
isp_I_Def_tank_can_2m[1] 99.9
SEND TO ACM
Check All Sensors to Confirm Accurate Readings
Flash Files into Truck
Connect With DDDL
Cofirm Parameter changes stayed in Modules
Clear Faults if nececcary
Ready to go!